Junction function
Balcony in ETICS wall — the most common detail for new-generation single-family houses built in ETICS technology.
Geometry similar to a balcony in a 3-layer wall, but cheaper — only two layers of termPIR® are used (instead of three):
- Wall — termPIR® ETX under render (ETICS).
- Balcony soffit — termPIR® ETX continuation of the same facing.
- Balcony floor — termPIR® WS/BWS under the screed.
The balcony soffit and the wall share the same facing (ETX glass veil) — continuous render application is possible from the wall under the balcony. Aesthetic continuity.
Critical installation aspects
- termPIR® ETX balcony soffit (item 06) — bonded to the underside of the reinforced concrete slab + mechanically fixed at min. 4 pcs/m², in edge zones 6 pcs/m².
- PIR caps dia. 62 mm (item 05) — eliminate thermal bridges at mechanical fasteners. Without caps, “ladybugs” become visible on the facade.
- Waterproofing (item 08) — heat-welded bitumen membrane turned up onto the wall by 15 cm under the drip flashing. Critical for the balcony — any leak means staining on the facade.
- 1.5% slope from the wall to the balcony edge — achieved with a wedge-shaped sloping layer (item 16). Required by PN-B-10250.
- Drip flashing with drip edge (item 14) — edge bent 90° over 30 mm prevents water from running down the facade (aesthetics + insulation protection).
- Balustrade (item 15) — fixings installed before the surface is laid; neutral frost-resistant silicone on the fasteners.
Key comparison with the 3-layer balcony
| Aspect | ETICS (this one) | 3-layer |
|---|---|---|
| Number of termPIR® layers in section | 2 (ETX + WS/BWS) | 3 (AL + ETX + WS/BWS) |
| Price per m² of balcony | baseline | +25-35% |
| Wall–balcony render continuity | yes (single ETX) | no (clinker cladding) |
| Typical application | new energy-efficient houses | premium villa |
Used in the external ETICS wall system.
Documentation
termPIR® catalogue — Residential Buildings (Gór-Stal, 2022), p. 39 — vertical section of balcony in ETICS wall.
Components in this junction
- 02
- 06
- 09
- 14 Balcony drip flashing with drip edge
- 05 Insulation fastener with PIR cap dia. 62 mm
- 01 External load-bearing wall
- 03 Mineral render on mesh
- 04 Balcony slab (reinforced concrete)
- 07 Ring beam and ceiling
- 08 Balcony floor waterproofing
- 10 PE foil
- 11 Cement screed
- 12 Balcony surface (porcelain stoneware)
- 13 Finishing plinth
- 15 Balustrade
- 16 Sloping layer (wedge-shaped)